Filter
Top Products
36
36
37
Configuration of the settings relating to the mail notification
[Notification]
Click the [Notification] tab on the "Alarm" page. (☞Pages13and14:Howtodisplay/operatethesetupmenu)
The settings relating to the alarm mail can be configured. It is necessary to configure the settings of the mail server
to perform the mail notification. (☞ Page 41)
■ Mail notification
[Mail server >>]
When "Mail server >>" is clicked, the [Mail] tab of the
"Server" page will be displayed. (☞ Page 41)
[Mail notification]
Select"On"or"Off"todeterminewhetherornottopro-
vide notification by e-mail according to the settings for
the "Alarm" and "Diag." checkboxes of "Destination of
notification" below.
Default:Off
[Alarm image attachment]
Select"On"or"Off"todeterminewhetherornotto
attach an image to the mail to be sent.
Default:Off
Note:
•Thesettingsfor"Imagecapturesize"ofthe"Alarm
image" section on the [Alarm] tab (☞ page 32) will
be applied to the size of the image to be attached.
■ Destination of notification
[Address 1] to [Address 4]
Enter the destination mail address. Up to 4 destination
addresses can be registered.
"Alarm" checkbox: When the checkbox is checked,
the mail notification will be performed upon an
alarm occurrence.
"Destination address": Enter the destination address.
To delete the registered address, click the [Delete]
button respective to the desired address.
Available number of characters: 3 - 128 characters
[Mail subject]
Enter the mail subject.
Available number of characters: 0 - 50 characters
[Mail body]
Enter the mail body.
Available number of characters: 0 - 200 characters