Filter
Top Products
[Auto slow shutter]
The electronic sensitivity enhancement (sensitivity up) can be carried out by adjusting the storage time of MOS.
The following are available for the recording duration.
SF135
SF135
SP105
SP105
: Off(1/30s), Max.2/30s, Max.4/30s, Max.6/30s, Max.10/30s, Max.16/30s
SF132
SF132
SP102
SP102
: Off(1/30s), Max.2/30s, Max.3/30s, Max.4/30s, Max. 8/30s
• Default: Off(1/30s)
IMPORTANT
• When “On” is selected for “Auto slow shutter”, frame rate may become lower. Noise or white dots
(blemishes) may sometimes appear.
Note
• When “AGC” is set to “Off” or “ELC(Maximum exposure time)” is set to other than “ELC(1/30s)”, “Auto
slow shutter” is set to “Off(1/30s)”.
SF135
SF135
SP105
SP105
:
• When “Max.16/30s” is selected, for example, sensitivity will automatically be increased up to x16.
SF132
SF132
:
SP102
SP102
:
• When “Max. 8/30s” is selected, sensitivity will automatically be increased to x8.
[Day & Night(electrical)]
Select switching between the color mode and the black & white mode from the following.
• Off: The color mode is selected.
• Auto: Switches from color to black-and-white images when the ambient brightness (illuminance) of the
camera is approx. 4 lx
SF132
SF132
SP102
SP102
/ approx. 2 lx
SF135
SF135
SP105
SP105
or less. It takes time to switch
between modes.
• Default: Off
[White balance]
Select a method of white balance adjustment from the following.
White color can be adjusted by “Red gain” and “Blue gain”.
• ATW1: Selects the automatic tracing white balance mode. The camera will constantly check the color
temperature of the light source and adjust the white balance automatically. Operating color temperature
range is approx. 2,700 K to 6,000 K.
• ATW2: Selects the automatic tracing white balance mode under a sodium lamp. The camera will adjust
the white balance automatically under a sodium lamp. Operating color temperature range is approx. 2,000
K to 6,000 K.
• AWC: Selects the automatic white balance control mode. This adjustment is suitable for a location where
a light source is stable. Operating color temperature range is approx. 2,000 K to 10,000 K.
• Default: ATW1
Note
• Under the following conditions, color may not be faithfully processed. In these cases, select “AWC”.
– When shooting a subject whose major part is a thick color
– When shooting blue sky or sun at sunset
– When shooting a subject whose luminance is too low
• When “AWC” is selected, click the [Set] button.
[Red gain]
Adjust the red color of images.
When the cursor is moved in the “+” direction, the red color will become thicker. When the cursor is moved in
the “-” direction, the red color will be thinner. Click the [Reset] button to reset the color to the default.
• Default: 128
Operating Instructions 109
11 Configure the settings relating to images and audio [Image/Audio]