Filter
Top Products
C1525M-B (10/02) 11
MOUNTING
The VMX200 can be placed on a flat surface, such as a shelf or table, or it can be mounted in a 19-inch (48.26 cm) equipment
rack.
Follow these instructions to mount the workstation in an equipment rack:
1. Attach the two adjustable support rails to the sides of the equipment rack using the eight 10-32 x .375-inch screws. Also
use the eight 10-32 nuts if the rack does not have threaded mounting holes.
2. Tighten the eight 10-32 x .250 screws.
3. Attach the two rack ears to the front side of the VMX200 using the four 10-32 x .250 screws.
4. Place the workstation on the support rails. Use the handles on the VMX200 for easier placement. Remove the rubber feet
from the VMX200 if placing it on top of another device that is already in the rack.
5. Fasten the rack ears to the rack using the four 10-32 x .750 screws.
RACK EARS
10-32 X .250
SCREWS
10-32 X .750
SCREWS
10-32 X .375 SCREWS
LEAVE SCREWS LOOSE UNTIL
SUPPORT RAILS ARE ATTACHED TO THE
RACK , AND THEN TIGHTEN.
RIGHT SID
E
MAKE SURE ARROWS FACE
TOWARDS THE FRONT OF THE RACK
10-32 X .250 SCREWS
SLIDE FRONT TO BACK TO ADJUST RAILS
TO THE CORRECT DEPTH OF RACK
LEFT SIDE
Figure 4. Rack Mount Installation