Filter
Top Products
14 C1525M-B (10/02)
VIDEO INPUTS
The VMX200-SYS and VMX200-SYS-1 have one video input. The VMX200-SYS-Q has six video inputs.
Follow these steps and refer to Figure 7 to connect the video:
1. Connect a spider cable to the video port on each model.
2. Connect the video input to the video source (for example, cameras or monitor output of a switch or multiplexer).
NOTE: Refer to the Installation/Operation Manual for each device you connect for further video connection information.
For the VMX200-SYS and VMX200-SYS-1, only the yellow composite (RCA) connector goes to another device. The other three
connectors are not used.
For the VMX200-SYS-Q, you can connect the six BNC connectors to other devices. For example, you can connect them to six
cameras. However, you can only drag-and-drop four of the cameras into the quad display monitor.
The six BNC connectors are as follows:
1. Input 1 (Red)
2. Input 2 (Green)
3. Input 3 (Blue)
4. Input 4 (Yellow)
5. Input 5 (Black)
6. Input 6 (White)
Although there are six video inputs, there are several applications that require only four. For example, you would normally
connect only four inputs to video outputs on a CM6800-48X8.