Filter
Top Products
C1572M (9/05) 51
4. Install the new card into slot 17 of the matrix bay as follows (refer to Figure 30):
a. Align the top and bottom edges of the card with the top and bottom card guides of the matrix bay.
b. Slide the card toward the rear of the matrix bay until the card is seated firmly with the connectors on the backplane and with the
associated rear panel card connector. If the audible alarm on the power supply is enabled, the alarm stops beeping and the Frame
Fault LED turns off.
c. To ensure proper operation of the CM9760-VMC card, reset the card by pressing the Reset button on the card.
For about five seconds, the audible alarm on the power supply beeps and the Frame Fault LED flashes red. The LEDs on the video
output card then indicate proper operation.
5. Reattach the front panel of the matrix bay.
Figure 30. CM9760-VMC Video Output Card Installation (Slot 17)
LEDs
CARD
GUIDE
VIDEO OUTPUT CARD
(SLOT 17)
CARD
HANDLE
FRAME
FAULT
LED
CARD
HANDLE
RESET
BUTTON
CARD
GUIDE