Pelco c2462m-e Camera Accessories User Manual


 
C2462M-E (3/09) 7
Installation
The installation methods for the ICS090 Series include the following options:
Mount to the surface of a ceiling or wall
Install in a suspended ceiling
Install in a fixed ceiling or wall
Mount to the surface of a 4S standard electrical box
Install in a 4S deep electrical box
SURFACE INSTALLATION: CEILING/WALL
Refer to Figure 2 on page 8 for the following steps. Refer to Figure 3 on page 8 if you are installing the unit
to the surface of a concrete ceiling or wall.
1. Pull the video and power wires through the ceiling/wall.
2. Connect the video cable and wires.
BNC: Connect the BNC connector from the Camclosure to a mating BNC connector.
Twisted pair: Connect the blue wire to Video +; connect the gray wire to Video -.
3. Connect the power wires (refer to Table A).
Table A. Power Input: Surface, Ceiling/Wall Installation
Voltage Red Wire Black Wire
12 VDC + Ground
24 VAC
AC operation only: If you a
re wiring more than one Camclosure to the same transformer, connect one
side of the transformer to the red wire on all units; connect the other side of the transformer to the
black wire on all units.
NOTE: Failure to connect all of the units in the same way will ca
use the cameras to be out of phase
with each other, which might produce a vertical roll when switching between cameras.