Filter
Top Products
10 C3426M-D (3/08)
8. Reinstall the back box inside the cover. For vandal-resistant installations, rotate the back box to
position the conduit plug opposite the notch on the side of the cover. Use the two 8-32 x 0.375-inch
Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.
Figure 2. Basic Surface Installation
4S ELECTRICAL BOX INSTALLATION
NOTE: You should install the camera module into the back box before installing the back box into the cover.
When installing the back box into the cover, rotate the camera module to access the mounting holes (refer
to Camera Module on page 16 for more information).
1. Attach an ICS110-AP adapter plate (not supplied) to a 4S box. Use two 8-32 x 0.75-inch Phillips flat
head screws (supplied with both the IS110 and the adapter plate).
2. Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the cover from
the back box.
3. Pull the video and power wires into the cover.
4. Attach the cover to the adapter plate with up to four 8-32 x 0.375-inch Phillips pan head screws
(supplied with the adapter plate). Use stainless steel hardware when installing the system outdoors.
5. Connect the video cable/wires:
• BNC: Connect the BNC connector from the unit to a mating BNC connector.
• UTP: Connect the blue wire to Video +; connect the gray wire to Video -.
8-32 X 0.375-INCH
PHILLIPS PAN HEAD
SCREWS WITH WASHERS
(SUPPLIED)
MOUNTING
SCREWS
(NOT SUPPLIED)
COVER
BACK BOX