Filter
Top Products
C3426M-D (3/08) 15
8. Connect the video cable/wires:
• BNC: Connect the BNC connector from the unit to a mating BNC connector.
• UTP: Connect the blue wire to Video +; connect the gray wire to Video -.
9. Connect the power wires, refer to Table F.
AC operation only: If you are wiring more than one Camclosure to the same transformer, connect one
side of the transformer to the red wire on all units; connect the other side of the transformer to the
black wire on all units.
NOTE: Failure to connect all AC powered units in the same way will cause the cameras to be out of
phase with each other, which may produce a vertical roll when switching between cameras.
Table F. Power Input: Side Conduit Installation
Voltage Red Wire Black Wire
12 VDC + Ground
24 VAC ~ ~