Filter
Top Products
14 C3426M-D (3/08)
SIDE CONDUIT INSTALLATION
NOTE: You should install the camera module into the back box before installing the back box into the cover.
When installing the back box into the cover, rotate the camera module to access the mounting holes (refer
to Camera Module on page 16 for more information).
1. Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the cover from
the back box.
2. Attach the cover to the mounting surface (hardware not supplied). Use stainless steel hardware
when installing the system outdoors.
3. Remove the conduit plug from the side of the back box.
4. Use a blunt tool to pull the wires and plug, located on the base of the back box, into the back box.
5. Insert the black plug (supplied) into the hole in the base of the back box.
6. Reinstall the back box inside the cover. Align the conduit plug with the notch on the side of the
cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and washers (removed earlier) to
secure the back box to the cover.
7. Install a 0.75-inch (1.91 cm) threaded conduit connector (not supplied) into the conduit hole in the
back box.
Figure 5. Side Conduit Installation
COVER
0.75-INCH CONDUIT
CONNECTOR
REMOVE
CONDUIT PLUG
8-32 X 0.375-INCH
PHILLIPS PAN HEAD
SCREWS WITH WASHERS
(SUPPLIED)
BACK BOX