Filter
Top Products
Pelco Manual C416M-C (1/98) 11
4.0 MAINTENANCE
Regularly scheduled maintenance will prolong the operational life and appearance
of the equipment.
Clean the dome with a nonabrasive cleaning cloth and antistatic cleaner that is
safe for use on acrylic plastic. Do not use kerosene or similar substances that can
scratch the surface.
The dome drive should also be inspected and any dust and debris blown off. Pay
special attention to the gear drives. After removing dust and debris a film of silicone
lubricant should be applied to the gears for prolonged life. It is recommended that
the unit be checked at six-month intervals.
No adjustments are required.
4.1 DOME DRIVE REMOVAL
1. Remove the back box trim ring or bezel. To remove a bezel, turn it about 1/2"
(1.27 cm) counterclockwise and pull down.
2. Turn off the power switch inside the back box.
3. Remove the hairpin clips from the latches.
4. Open one of the latches.
5. Grasp the unit with one hand to prepare for the 10- to 13-pound (4.5 to 5.9 kg)
load.
6. Open the other latch and lower the dome drive.