Filter
Top Products
Pelco Manual C540M (6/98) 15
4. Up to ten user-defined icons.
To upload a keyboard setup to all keyboards connected to a specific CM9760 system
in a multiple-node CCTV installation, you must know the appropriate node number.
To upload a keyboard setup to a specific keyboard connected to a specific CM9760
system in a multiple-node CCTV installation, you must know the keyboard number
(1-96) and the node number.
3.2.12 Assigning Logical Camera Numbers
Logical (user-defined) camera numbers can be assigned to directly controlled cam-
eras. This avoids the need to change physical camera numbers. To assign a logical
camera number:
1. In
setup mode
, select .
2. Select the
camera assign
screen using and/or .
3. Select the physical camera number using and/or .
4. Select .
5. Enter a logical camera number.
6. Select .
To configure the relays of directly controlled cameras:
7. Select
.
8. Use the auxiliary icons, such as
, to set the camera’s relay action to
either toggle or momentary status.
9. Press
.
10. Repeat steps 3-9 to configure additional cameras.
11. Select
.
3.2.12.1 Downloading Keyboard to Keyboard
In order to download/upload setups directly between keyboards, the keyboards
can be connected using COM 1 and/or COM 2 (the ports are interchangeable in
this case, that is, COM 1 or COM 2 to COM 1 or COM 2) or through COM 3.
The COM port sockets are on the underside of the keyboard (see Figure 4).
The data pin connections are shown in Figure 5.
Setups are downloaded keyboard to keyboard by:
1. In
keyboard setup
mode, use and/or to select the COM port that
is being used to download setup information:
a) KB-KB COM 1 b) KB-KB COM 2 c) KB-KB COM 3
2. To download setup information
from
a connected keyboard select
or,
to upload setup information
to
a connected keyboard, select .
> TARGET 9750/9760
NODE LOCAL
KBD# ALL/ANY
KEYBOARD SETUP
> TARGET KB - KB COM 1
NODE
KBD#
KEYBOARD SETUP
NOTE:
Physical cameras 0-15 are
connected to COM 1, while physical
cameras 16-31 are connected to
COM 2.
NOTE:
Each camera receiver/driver
may have up to eight relays, the ac-
tion of which can be specified as ei-
ther momentary or toggle.
PHYSICAL LOGICAL 12345678
0 0 TTTTMMMM
> 1 0 TTTTMMTM
2 0 TTTTMMMM
3 0 TTTTMMMM
AUX ASSIGN
PHYSICAL LOGICAL 12345678
> 0 0 TTTTMMMM
1 0 TTTTMMMM
2 0 TTTTMMMM
3 0 TTTTMMMM
CAMERA ASSIGN