Pelco CCC1390H Security Camera User Manual


 
20 C2924M-A (5/05)
Quick Setup
Several CCC1390H Series camera settings can be changed directly from the rear panel button. When a rear panel indicator is lit, the correspond-
ing option is enabled. You can change the following options directly from the rear panel:
AGC Press the button up to enable or disable automatic gain control (AGC). Refer to Automatic Gain Control (AGC) for more
information.
D/N Press the button left to enable or disable day and night mode. When enabled, the AUTO mode is selected. When disabled, the
COLOR mode is selected. Refer to Day and Night for more information.
You cannot change day and night mode when AGC is disabled; the camera uses the COLOR mode.
SENS Press the button down to enable or disable DSS (SENS). Refer to Digital Slow Shutter (DSS (SENS)) for more information.
If you disable SENS on the rear panel, the camera saves the DSS (SENS) value on the EXPOSURE SETTING menu.
WD Press the button right to change the auto exposure mode. When this indicator is lit, WDR is selected. Otherwise, the NORMAL
auto exposure mode is selected. Refer to Auto Exposure for more information.
NOTES:
To enable the rear panel indicators, the LED setting on the CAMERA SETUP menu must be set to ON (the default).
To enable the quick setup feature, the SWITCH setting on the CAMERA SETUP menu must be set to ON (the default).
Figure 9 shows the rear panel indicators and their corresponding button presses.
Figure 9. Quick Setup Indicators and Presses
AGC
WD
SENS
D/N