Pelco DF5 Security Camera User Manual


 
10 C1458M-J (9/08)
LOWER DOME
IN-CEILING MODELS
1. Snap the clip on the end of the trim ring leash into the hole on the lip of the back box.
2. Line up the snaps on the trim ring with the mounting screws on the back box. Snap the trim ring into the plastic snap washers on the
mounting screws.
Figure 10. Installing the Lower Dome for In-Ceiling Models
PENDANT MODELS
1. Hanging down from the back box is a flexible strap called the trim ring leash. Lift the lower dome near the back box so that the trim ring
leash touches the lower dome.
2. Look inside the lower dome and note the two raised retainer screws. Slide the hole in the end of the trim ring leash over one of the raised
retainer screws. Tuck the end of the trim ring leash behind the raised sheet metal stop, and make sure the leash will hold the lower dome.
3. Line up the two notches on the outside edge of the lower dome with the two captive screws on the back box. Push the lower dome inside
the back box, and tighten the screws to secure the lower dome.
Figure 11. Installing the Lower Dome for Pendant Models