Filter
Top Products
C1458M-J (9/08) 9
CAMERA AND LENS
If the camera and lens are already installed, begin with step 2.
1. If applicable, extend the lens to the maximum length before installing the camera in the back box. Attach the camera to the tilt table with
the 1/4-20 screw, flat washer, and lock washer (supplied).
Figure 8. Installing the Camera and Lens
2. For indoor models, connect the power wires and video cable to the camera.
3. For outdoor models, connect the video cable to the camera. Connect the power wires to the circuit board mounted on the side of the back
box. Connect the wires to the connectors marked AC IN HI (line voltage), AC IN NT (neutral), and GND.
Attached to the circuit board are a black wire and a red wire with spade lugs on the end; connect these to the power connectors on the
camera.
Figure 9. Connecting Camera Power for Outdoor Models
4. Turn on power and adjust the tilt table for desired viewing of the camera on the monitor. Refer to the camera and lens manuals to set up the
camera and lens for proper operation.
IN-CEILING MODEL
PENDANT MODEL
1
2
3
4
5
6
7
8
9
10
HI
NT
GND
AC
IN
TO CAMERA
POWER INPUT
OUTDOOR MODELS
24 VAC
INPUT