Filter
Top Products
8 PELCO Manual C460M-E (7/95)
Figure 9. Wall Mounting
4.4.1 Mounting the ED28/ED2820 Series
4.4.1.1 Wall Mounting
The ED28/ED2820 series may be mounted directly to a
wall or vertical surface. To attach the enclosure to a
vertical surface, perform the following (see Figure 9):
1. Using the enclosure or the template supplied (see
Figure 12), mark the location of the four (4) mount-
ing holes. If the control and power cables are to
pass through the mounting surface, mark the large
center hole as well.
2. Drill four (4) mounting holes according to the
fasteners being used (minimum 5/16-inch diam-
eter, not supplied).
3. Mount the enclosure to the surface using the re-
quired fasteners. If needed, route the control cables
through the mounting structure.
4. Install pan/tilt with camera/lens.
Figure 8. Camera/Lens Mounting
NOTE: VALUES IN PARENTHESES ARE CENTIMETERS; ALL OTHERS ARE INCHES.