Filter
Top Products
10 Pelco Manual C1432M-C (11/99)
If you are installing the wiper kit in a Legacy enclosure, power for the wiper is
supplied through the 37-pin connector on the pan/tilt unit as follows:
AC High Pin 15
AC Neutral Pin 16
Wiper On/Off Control Pin 25
If you are installing the wiper kit in a non-Legacy unit, power for the wiper is sup-
plied as follows:
AC High Pin 1 of TB2 on the O/I-PCB circuit board (refer to Figure 8)
AC Neutral Pin 2 of TB2 on the O/I-PCB circuit board
Wiper On/Off Control Pin 1 of TB3 on the O/I-PCB circuit board
Pins 15 and 16 on Legacy enclosures and pins 1 and 2 of TB2 on non-Legacy
enclosures also provide power for other enclosure accessories, such as the fan
and heaters. Make sure that this wiring can handle the additional power for the
wiper. All window wiper assemblies use 15 watts of power.
d. Replace the plastic cover over the power supply on the circuit board.
25. Reinstall the camera and sled.
26. Close the enclosure lid.
27. Turn on power to the enclosure.