Filter
Top Products
Pelco Manual C1432M-C (11/99) 7
WINDOW WIPER KIT INSTALLATION
For the following instructions, refer to Figure 10, if necessary. Table B lists the parts shown
in Figure 10.
1. Turn off power to the enclosure.
2. Unlatch and raise the enclosure lid. The gas spring will hold the lid in place when it is
fully opened.
3. Remove the camera and sled.
4. EH5723/EH5723L and EH5729/EH5729L Models Only - Remove the vent
grill inside the enclosure at the rear of the unit.
5. EH5723-1, -2, -3/EH5723L-1, -2, -3 Models, and EH5729-1, -2, -3/
EH5729L-1, -2, -3 Models Only
a. Unplug the electrical connector on the fan.
b. Remove the three screws that secure the fan plate and fan to the enclosure.
c. Remove the fan plate and fan.
d. Remove the fan from the fan plate.
e. Attach the fan to the fan plate of the window wiper assembly in the same orienta-
tion that it was attached to the original fan plate.
6. Refer to Figure 5 and insert the wiper shaft into the green bushing on the fan plate of
the wiper motor/control assembly.
7. Insert the motor/control assembly into the enclosure and attach the assembly to the
enclosure with the hardware that is supplied:
a. Slip the blue, white, and black wiper wires into the slot at the bottom of the fan
plate so that the white plug is on the opposite side of the fan plate from the wiper
circuit board housing.
b. On all models except the EH5723 and EH5729, remove the screws on the sides
of the circuit board in the enclosure so that the circuit board can be moved out of
the way to install the wiper motor/control assembly.
c. Place the assembly into the enclosure with the wiper circuit board housing facing
toward the rear of the enclosure and the fan plate against the camera sled track.
d. Hook the rear of the circuit board mounting over the screw installed at the top of
the enclosure’s rear panel. Secure the circuit board mounting to the enclosure
with the acorn nut.
e. Attach the bottom right and bottom left sides of the fan plate to the camera sled
track with screws and lock washers.
f. On all models except the EH5723 and EH5729, reinstall the circuit board.
8. Reconnect the electrical connector to the fan.
9. Remove the latch on the side of the enclosure where the wiper shaft is located.
10. Slide the support bracket onto the wiper shaft. Using the longer screws supplied in the
wiper kit, attach the latch and support bracket to the enclosure.
11. Slide the flange bearing over the bearing pin as shown in Figure 5, and slide the cam
track over the flange bearing. Only the tautness of the drive shaft holds the flange
bearing in place.
12. Refer to Figure 6 and slip the flex coupler over the drive shaft.
13. Remove the hole plug from the wiper shaft hole in the front of the enclosure.
14. From the outside of the enclosure, install the green bushing into the wiper shaft hole.