Filter
Top Products
10 C307M-K (11/07)
7. Install mount; refer to the installation manual supplied with the mount for instructions.
8. Turn on the power. If the red LED lights, turn off the power and proceed to the next step. If the red LED does not light, refer to
Troubleshooting on page 60.
9. Plug the male Esprit system connector, located on the bottom of
the pan/tilt, into the female Esprit system connector located on the
transformer module. Align the pan/tilt part number with the
alignment label of the base, and then attach the pan/tilt to the
base with three 1/4-20 nuts and washers (supplied).
10. Set the receiver address and system baud rate by configuring DIP
switches SW1 and SW2.
NOTE: Switch settings have no effect on Coaxitron control signals.
The Esprit will sense and automatically select input from Coaxitron
control signals in either standard or extended mode.
To set the DIP switches:
a. Remove the plug from the left cover of the pan/tilt. It is not
necessary to remove the pan/tilt cover.
b. Set the baud rate (SW1) and receiver address (SW2).
For switch settings refer to the labels located on the inside
lid of the housing or Table A and Table B in the Appendix on
page 62.
c. Replace the plug.
11. Refer to Operation on page 13 and Programming on page 16 manual for instructions on how to use your ES30C/ES31C Series Esprit
integrated positioning system.
AUX 2
AUX 2 COM
AUX 2
AUX 2 COM
ESPRIT
NOTE: CURRENT MUST NOT EXCEED 40 mA.
ORANGE WIRE
BLUE WIRE
USER
ACCESSORY
D1
1N4005
K1
OMRON G5V-1-DC12
V1
32 VDC
PART
NUMBER
MALE SYSTEM
CONNECTOR
ALIGNMENT
LABEL
FEMALE
SYSTEM
CONNECTOR