Filter
Top Products
12 C307M-K (11/07)
HOW TO REINSTALL THE PAN/TILT COVER
The pan/tilt covers must be properly seated and have a tight seal (all the way around) when installed.
To reinstall the pan/tilt cover, do the following:
1. Properly position the cover and slide it into place. The sides of the cover must fit under the front and back rain guards of the pan/tilt, and
the top of the cover must seat against the lip of the top gasket.
2. Apply pressure and push down the top of the cover to align the fastener holes.
3. Insert the Phillips screw and tighten. Tighten until the screw will not turn.
THIS SIDE IS
IMPROPERLY
INSTALLED
THIS SIDE IS
PROPERLY
INSTALLED
NOT SEALED
GAP
TOP GASKET
FRONT
RAIN
GUARD