Filter
Top Products
2 Pelco Manual C1472M-C (10/05)
INSTALLATION
The following items are supplied:
1 HS4514 Series enclosure
1 #10 socket for tamper-resistant screws (1/4-inch drive tool not provided)
1 Three-pin plug with leads (included with heater -1/-2/-3 models)
2 1/4-20 Phillips head screws (to mount enclosure)
1 Steel eyebolt
Enclosure Mounting
1. Place the enclosure on a flat surface with the top facing up. Open the enclosure using the
following procedure:
a. Remove the four tamper-resistant screws securing the enclosure cover using the
#10 socket for tamper-resistant screws (provided) and your 1/4-inch drive tool. (Drive
tool not provided.)
b. Separate the top and bottom enclosure sections.
2. Remove the camera sled from the rail by loosening the two 10-32 Phillips head screws
and sliding the sled to the rear.
3. Install two wiring fittings in the bottom of the enclosure.
If the enclosure is installed outdoors, be sure that watertight fittings are installed. If con-
duit or other wiring fittings are used, be sure the fittings are sealed to prevent water from
getting inside the enclosure.
4. Reassemble the top and bottom enclosure sections and lift the enclosure into place for
mounting.
OPTIONAL – The enclosure can easily be lifted with the optional steel eyebolt (eyebolt
included). Install the steel eyebolt and lift the enclosure using the following procedure:
a. Remove the Phillips head screw and washer from the captive nut located in the back
of the enclosure. Set the Phillips head screw aside.
b. Install the steel eyebolt in the captive nut. Firmly tighten but do not overtighten.
c. Attach a hoist line to the steel eyebolt. Be sure the hoist line and any lifting hardware
are sufficiently strong enough to support the weight of the enclosure. Hoist the
enclosure into place.
5. Locate the two threaded mounting holes on the bottom of the enclosure. Using two 1/4-20
screws that do not exceed 5/8-inch (1.59 cm) in length (not supplied with the enclosure),
mount the enclosure to a fixed mount.
If you lifted the enclosure with the aid of the steel eyebolt, remove the eyebolt and reinstall
the Phillips head screw and washer.
6. Open the enclosure using the previously described procedure.
Proceed to the
Enclosure Power
section.
WARNING:
In order to
maintain watertight
standards, proper
cabling must be used when
wiring the enclosure. Use of flat
cable or multiple cables will
prevent the proper seal of
connectors. Outdoor rated
sheathing should cover multiple
cables.
NOTE:
After the enclosure is
mounted, opening the enclosure
is more convenient using the
following procedure:
a. Remove the two tamper-
resistant screws securing the
front of the enclosure cover.
b. Loosen, but do not remove,
the two tamper-resistant
screws securing the rear of
the enclosure cover.
c. Push the top of the en-
closure back approximately
1/4-inch (0.63 cm) and flip
the top open.
d. Reverse the procedure to
close.