Filter
Top Products
6 Pelco Manual C1472M-C (10/05)
b. Wire the lens controller to the 10-connector INPUTS terminal on the circuit board as
follows:
Lens Common Connector 1 Preset Common Connector 5
Focus Connector 2 Preset Focus Connector 6
Zoom Connector 3 Preset Zoom Connector 7
Iris Connector 4 Preset High Connector 8
Proceed to the
Wiring Camera to Power
section.
Wiring Camera to Power
HS4514 Model Only
Bring the camera wiring into the enclosure. If you are using 24 VAC refer to Table A, 24 VAC
Wiring Distances, to determine the size of wire to use. Connect the power leads to the camera.
Proceed to the
Final Installation
section.
HS4514-1/-2/-3 Models with Heater
Camera with same voltage requirements
If the camera will use the same voltage as the enclosure’s heater, there are two options for
connecting power:
1. A three-pin plug with leads is supplied as loose equipment. Connect the leads from the
plug to the camera as follows:
Brown AC HI
Blue AC NT
Green Ground
Refer to Figures 1 and 2 and connect the plug to the CAM 1 socket on the circuit board.
2. If both the camera and enclosure use 120 VAC and you ordered the optional 120 VAC
electrical outlet accessory (O/I OUTLET), connect the 120 VAC plug to the camera and
the three-pin plug to CAM 1.
Proceed to the
Final Installation
section.
Camera with different power requirements
1. Bring in wires for AC high and AC neutral. If you are using 24 VAC, refer to Table A.
Connect the wires as follows:
Connect AC high to connector 9 of the 10-connector INPUTS terminal block.
Connect AC neutral to connector 10 of the 10-connector INPUTS terminal block.
2. Connect the leads from the two-pin plug, which is supplied as loose equipment, to the
camera as follows:
Brown AC HI
Blue AC NT
Refer to Figures 1 and 2 and connect the plug to the CAM 2 socket on the circuit board.
Proceed to the
Final Installation
section.
Final Installation
1. Adjust the focus and iris on the camera, if necessary.
2. Reassemble the top and bottom enclosure sections.
3. Install and tighten the four tamper-resistant screws in the enclosure cover. Do not over
tighten.
4. If the enclosure is installed outdoors and has watertight fittings installed on the bottom of
the enclosure, be sure the fittings have been tightened enough to prevent water from
getting inside the enclosure.
WARNING: Camera
damage possible.
You can damage your
camera if you connect it to the
wrong connector.
If your camera will use the same
voltage as the enclosure, plug
the camera into the CAM 1
socket on the circuit board inside
the enclosure.
If your camera’s voltage will be
different from the enclosure’s
voltage, plug the camera into the
CAM 2 socket only.
DO NOT
plug the camera into the CAM 1
socket or you can damage your
camera. CAM 1 has enclosure
voltage on it.
BE CAREFUL!
REMEMBER, CAM 1 IS
ENCLOSURE POWER.
NEVER PLUG YOUR
CAMERA INTO CAM 1 IF
THE CAMERA’S VOLTAGE
IS DIFFERENT FROM THE
ENCLOSURE’S VOLTAGE.