Filter
Top Products
Pelco Manual C1973M-B (8/03) 5
MRD ADDRESS SETTINGS
A camera address setting is required for the controller/switcher to communicate with the
MRD1400HZ16. The default setting for the MRD is Receiver Address 1. If you are using
more than one MRD, each unit must have a different Receiver Address.
To change the address setting of the MRD, refer to Figure 1 and Table B.
Table B. MRD DIP Switch Settings
MRD DIP Switch Setting
12 345
1 Off Off Off Off Off
2 On Off Off Off Off
3 Off On Off Off Off
4 On On Off Off Off
5 Off Off On Off Off
6 On Off On Off Off
7 Off On On Off Off
8 On On On Off Off
9 Off Off Off On Off
10 On Off Off On Off
11 Off On Off On Off
12 On On Off On Off
13 Off Off On On Off
14 On Off On On Off
15 Off On On On Off
16 On On On On Off
17 Off Off Off Off On
18 On Off Off Off On
19 Off On Off Off On
20 On On Off Off On
21 Off Off On Off On
22 On Off On Off On
23 Off On On Off On
24 On On On Off On
25 Off Off Off On On
26 On Off Off On On
27 Off On Off On On
28 On On Off On On
29 Off Off On On On
30 On Off On On On
31 Off On On On On
32 On On On On On
Receiver
Address