Philips 10FF2 Digital Photo Frame User Manual


 
3. Getting started
3.1 Placing the product
The PhotoFrame should be placed on a flat
surface and close to a power socket. Keep it
away from high temperatures and high levels of
moisture
3.2 Connecting to the mains
Connect the supplied power cable from
PhotoFrame to a power outlet.
Click
Note:
For safety reason and best stability Philips
recommend to adjust the stand with the angle
defined by the two clicked position. Using other
positions may cause the PhotoFrame to fall and
is under the entire responsibility of the user.
3.3 Charging the batteries
The batteries take approximately 2 hours to
be fully charged, when PhotoFrame is off and5
hours when it is on. Connect the PhotoFrame
to a power outlet as shown above. The internal
battery will start charging and the battery LED
turns blue and flashes.
3.4 Turning on your PhotoFrame
Press the power ON/OFF button.
The power LED will be blue and a slide show
will play.
3.5 Initial Setup
3.5.1 Access the Main Menu
The main menu can be accessed by either
pressing the menu button during a slide show
or photo or by left clicking the controller
from any menu item until you are returned to
the main menu.
3.5.2 Selecting your preferred language
1
• Press the menu button to access the
MainMenu.
• Navigate down to highlight the setup
icon.
• Navigate right or press the OK button to
access the setup menu.
8
Getting Started