Philips 10FF2 Digital Photo Frame User Manual


 
2.1.2 Control Buttons
1
2
3
4
5
1. Play/Stop | Slideshow
2. Navigation controller | OK
3. Menu
4. Reset Button
5. Power ON/OFF
Use your PhotoFrame by pressing the control
buttons in the back.
The control buttons and instructions are
shown at the bottom of the menu screen.
Use the navigation controller to move
between the menus. Move it left and right to
cycle through the menu tree.
2.1.3 Connections
Memory Card
Photo display (underside)
A. CF Card
B. SD/ MMC /MS / xD Card
Inserting a memory card:
Insert the memory card into the slot in the
frame.
For a Compact Flash card, firmly slide card in
the larger slot end first and face DOWN.
For a xD, SD, MMC, or Memory Stick card
slide card in the smaller slot end first and face
UP until it locks in-place.
After a few seconds photos on the memory
card will display and a slideshow will start.
Please DO NOT remove the memory card
just after inserting it in PhotoFrame or when
PhotoFrame is counting the Photo. Wait until
the screen is stable
Removing a memory card:
To remove the Compact Flash card, pull out
the card slowly.
To remove the xD, xD, SD, MMC, or Memory
Stick card, push the card again to unlock and
then pull out the card.
Note:
To copy photo from the memory card to the
PhotoFrame read the copying photo section.
6
Your PhotoFrame