Filter
Top Products
110
VQT2L35
When the status indicator is flashing at a
particularly fast or slow rate, the
following should be considered.
Flashing with approx. 4 second period
(off for approx. 2 seconds, on for approx.
2 seconds):
≥ The battery may be over-discharged, or
the battery temperature may be high or
low. The battery will charge, but it may
take several hours for normal charging to
begin.
Flashing with approx. 0.5 second period
(off for approx. 0.25 second, on for
approx. 0.25 second):
≥ The battery is not charged. Remove the
battery from the unit, and try charging
again.
≥ Check that the terminals of the unit or
battery are not dirty or covered in a foreign
object, and connect the battery correctly
once again. If a foreign object or dirt is
present, turn off the unit before removing.
≥ The battery or environment is at an
extremely high or low temperature. Wait
until the temperature has returned to an
appropriate level and try charging again. If
you are still unable to charge, there may
be a fault in the unit, battery or AC
adaptor.
Lamp turns off:
≥ Charging has finished.
≥ If the status indicator stays off despite the
charging being unfinished, there may be a
fault in the unit, battery or AC adaptor.
≥ Refer to page 109 for details on the
battery.
≥ The memory capacity indicated on the
label of an SD card is the total of the
capacity for copyright protection and
management and the capacity which can
be used on the unit, a PC etc.
≥ Do not apply strong shocks, bend, or drop
the SD card.
≥ Electrical noise, static electricity or the
failure of this unit or the SD card may
damage or erase the data stored on the
SD card.
≥ During long periods of use, it is normal for
this unit and the SD card to become
slightly warm and is not a malfunction.
When the card access lamp is lit, do not:
jRemove the SD card
jTurn the unit off
jInsert and remove the USB cable
jExpose the unit to vibrations or shock
Cautionary points when handling
≥ Do not expose the terminals of the SD
card to water, garbage or dust.
≥ Do not place SD cards in the following
areas:
jAreas exposed to direct sunlight, or in
high-temperature areas such near
heating equipment.
jIn very dusty or humid areas.
jLocations susceptible to significant
difference in temperature (condensation
can occur).
jWhere static electricity or
electromagnetic waves occur.
≥ To protect SD cards, return them to their
cases when you are not using them.
When disposing of or giving away an SD
card, note that:
≥ Formatting and deletion simply change the
file management information and cannot
be used to completely erase the data in an
SD card.
≥ We recommend that you physically format
an SD card before disposing of or giving
away the SD card.
About charging errors About SD cards
SDRS50&H85GN-VQT2L35_mst.book 110 ページ ２００９年１２月２９日 火曜日 午前１０時３０分