for firmware update.
2. Make sure that only you access this IR IP Camera at this
moment
3. Disable Motion Detection function.
4. Select “Firmware name”
5. Select the Firmware binary file. (Note that it must make sure
that the Firmware only applies to this device, once update, it
will be burned into FLASH ROM of system.)
6. Once the firmware file was selected, select
“Upgrade”.
7. The upgrade progress information will be displayed
on the screen.
8. A message will be shown while the firmware
upgraded. Once the upgrading process completed,
the device will reboot the system automatically.
9. Please wait for 80 seconds, and then you can use IP Wizard
to search the device again.
Warning!!! The download firmware procedure cannot be interrupted. If the power
and/or network connection are broken during the download procedure, it might
possibly cause serious damage to the IR IP Camera.
Please be aware that you should not turn off the power during updating the firmware
and wait for finish message.
Furthermore, do not try to upgrade new firmware if it’s not necessary.
System Restart: The IR IP Camera is restarted without changing any of the
settings.
51