Filter
Top Products
traversal when your device is located on an intranet (LAN) and you wish to make it available from
the other (WAN) side of a NAT router. With NAT traversal properly configured, all HTTP traffic to an
external HTTP port in the NAT router will be forwarded to the device.
UPnP To enable or disable the UPnP service here.
Friendly Name Shows the friendly name of this device here.
UPnP NAT Traversal When enabled, the device will attempt to configure port mapping in a
NAT router on your network, using UPnP™. Note that UPnP™ must be
enabled in the NAT router first.
Port Range The port range will open in NAT router.
External IP Address Show the IP address and port for WAN access through Internet. If NAT
traversal is configured successfully, user can use this IP address and
port to access this device.
3.5.6 IP Filter
You can enter different user’s IP address which are allowing enter or denying by the device.
41