Filter
Top Products
masterpage:Left
filename[D:\MVC-CD1000 kaihan\3062473121\3062473121MVCCD1000UC\02GB-
MVCCD1000UC\10add.fm]
66
model name1[MVC-CD1000]
[3-062-473-12(1)]
Your camera is supplied with a
vanadium-lithium battery installed so
as to retain the date and time, etc.,
regardless of the setting of the POWER
switch. The vanadium-lithium battery
is always charged as long as you are
using your camera. The battery,
however, will get discharged gradually
if you do not use your camera. It will
be completely discharged in about six
months if you do not use your camera
at all. Even if the vanadium-lithium
battery is not charged, it will not affect
the camera operation. To retain the
date and time, etc., charge the battery if
the battery is discharged.
Charging the vanadium-lithium
battery:
• Connect your camera to house
current (mains) using the AC power
adaptor supplied with your camera,
and leave your camera with the
power turned off for more than 24
hours.
• Or install the fully charged battery
pack in your camera, and leave your
camera with the power turned off for
more than 24 hours.
If any problem occurs, unplug your
camera and contact your nearest Sony
dealer.
On discs
Be sure to use only 8 cm CD-Rs. You
cannot read or write data on other type
discs that does not correspond to this
camera.
• Do not clean a disc using a cleaner
before recording. Use a
commercially available blower to
remove dust.
• If fingerprints, dust, drop of water, or
oilmakesthebluesideofadiscdirty,
the camera may not properly record
an image on the disc. You should
handle a disc with a lot of care.
• Ifadiscdoesbecomedirty,wipeitin
a straight line from center to edge
with a soft dry cloth or a soft cloth
lightly moistened with a mild
detergent solution. You can use a
commercially available CD cleaner.
• Do not use any solvent (benzine,
thinner, static protection product,
record cleaner, etc.) to clean a disc.
On vanadium-lithium battery
On cleaning
01cov.book Page 66 Wednesday, July 19, 2000 10:33 AM