SafeGuard 20071 Security Camera User Manual


 
EXTRA OPTIONS
28 MARMITEK
6. Choose 1 for CHIME ON or 2 for CHIME OFF.
7. Press CLEAR again to quit the menu. To confirm your choice, press 1 for Yes or 2 for No. If you choose Yes, you will quit the
menu. If you choose No, you go back to the main menu.
8. If you see a note () on the display, the chime is activated.
The chime function also works for the wired inputs on zones 31 and 32.
The chime function of the wired inputs on zones 31 and 32 always works and cannot be switched off.
If you want to deactivate the chime, use the wired input of the door/window sensor.
9.3 Using wired inputs
The SC9000 console has two inputs for wired sensors. These sensors need to be of type NC (normally closed contacts).
There should not be any power on these inputs (potential-free).
Connecting a wired sensor:
1. Open the top compartment on your console.
2. You will see two wired inputs.
3. Remove the wire bridge and connect your wired sensor.
4. Close the top compartment of your console and enter your PIN code to
remove the word TAMPER from the display.
5. The wired sensor is now ready for use.
The two screws on the left are for zone 32, the two on the right for zone 31.
9.4 Adding a wired sensor to the Door/Window Sensor DS90
The DS90 Door/Window Sensor has a contact for an extra wired sensor.
These sensors need to be of type NC (normally closed contacts).
There should not be any power on this contact (potential-free).
A few examples:
Securing a window with multiple magnetic contacts.
Adding extra sensors to your Marmitek system, e.g. smoke detectors,
temperature sensors, sensors to detect electrical failures, etc.
1. Open the transmitter part of the DS90 by removing the screw.
2. Remove the wire bridge from the connection for the wired sensor (2).
3. Connect your sensor.
The wired contact has its own zone on the console. You can register the contact
using the procedure in 4.1.3 (to register a sensor, activate the alarm with your
sensor in step 5).
The setting of the MIN/MAX switch (entry delay) of the DS90 is valid for both
the magnetic contact and the wired sensor.
1
2
20071_20070228_UG_SC9000_EN 08-03-2007 10:07 Pagina 28