Filter
Top Products
☺ If you set the UnitCode for the console to e.g. A16, the comfort lighting will get addresses A16 and A1.
To change the UnitCode:
1. To access the menu, press the menu or menu button. The display will now read ‘ENTER PIN’.
2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). For every digit entered, a * will appear
on the display.
3. When the PIN code has been entered correctly, the word ‘INSTALL’ will show up on the display.
4. Use the menu buttons / to go to menu item 7. OPTIONS. Press OK to select this menu item. You can also go to this menu
item directly by pressing a 7 on the number pad.
5. Use the menu buttons / to go to menu item UNITCODE. Press OK to select this menu item.
6. Use the menu buttons / to select the desired UnitCode and press OK.
7. Press CLEAR again to quit the menu.
11. Telephone functions
11.1 Calling the security system
The SC9000 alarm system is equipped with a call-in function. This means that you can ring your console remotely via any
telephone or mobile phone. You can also control your lights and devices via your phone. The system has a built-in speech chip
that guides you through the menus.
11.2 Activating the call-in function
The call-in function is switched off in the factory settings. You can switch the function on via the menu OPTIONS/ANSWER TYPE.
You can choose one of the following three options:
ANSWER ON:
Call-in activated. The time delay before the console answers the phone can be set in the menu DELAYS/ANSWER DELAY (see 8.1).
The standard delay is 30 seconds. If you use an answer phone or voice mail, we advise you to use option 3: VOICE MAIL.
ANSWER OFF:
the call-in function is deactivated (standard setting).
VOICE MAIL:
Call-in activated. Choose this option when you use the standard voicemail system offered by your telecom supplier. To access the
console, ring your home number twice. Let the phone ring for 10 seconds the first time. Hang up the phone and ring the number
again after 10 seconds, but within 30 seconds. The console will answer the phone.
Setting the call-in function:
1. To access the menu, press the menu or menu button. The display will now read ‘ENTER PIN’.
2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). For every digit entered, a * will appear
on the display.
3. When the PIN code has been entered correctly, the word ‘INSTALL’ will show up on the display.
4. Use the menu buttons / to go to menu item 7. OPTIONS. Press OK to select this menu item. You can also go to this menu
item directly by pressing a 7 on the number pad.
5. Use the menu buttons / to go to menu item ANSWER TYPE. Press OK to select this menu item.
6. You can now select ANSWER ON, ANSWER OFF or VOICE MAIL.
7. Use the menu buttons / to go to the desired menu item and press OK.
8. Press CLEAR again to quit the menu.
EXTRA OPTIONS
33SAFEGUARD / TOTALGUARD
20071_20070228_UG_SC9000_EN 08-03-2007 10:07 Pagina 33