Filter
Top Products
102
FAQ
[Case 9] When I open the Device Manager (by clicking Start (Settings) Control
Panel (Performance and Maintenance) System (Hardware) Device
Manager), there are Unknown Devices or Other Devices entries with a
yellow question mark(?) beside them or devices with an exclamation mark(!)
beside them.
Right-click on the entry with the question(?) or exclamation (!) mark and select
"Remove". Restart the PC and connect the camera the again.
For Windows 98 PC, remove the camera driver also, restart the PC, and then
reinstall the camera driver.
Double-click on the entry with the question(?) or exclamation(!) mark, click the
"Driver" tab, and click [Update Driver] or [Reinstall Driver]. If a message appears
asking you to specify the location where the appropriate driver for the device is,
specify the "D:\Digimax430 370\Samsung Digimax.KENOX Installation" folder
(where D: is the drive letter of the CD-ROM where the driver CD is inserted).
If you installed an incorrect codec onto your PC, the movie clip may not play back on the PC.
1. Check whether the JPEG Decoder provided with the camera is installed.
If you didn't install the camera driver, please install the JPEGCODE included in the
application S/W CD-ROM. If not, the movie clip may not play back on the PC.
[ Installing the JPEG Decorder ]
1) Insert the CD provided with the camera.
2) Run the windows explorer and select the CD-ROM drive.
3) Select the JPEG Codec Installation folder in the JPEG_Decorder folder and double
click the Setup.exe file. The codec will be installed.
Please check the following if the movie clip doesn't play back.
2. Compatible problems with the codecs installed onto the PC.
If the movie clip doesn't play back after installing the JPEG Decorder, refer to the
following.