Samsung SC- D375(H) Camcorder User Manual


 
ENGLISH
ESPAÑOL
9393
USB Interface (SC-D375(H)/D975 only)
Using USB Interface
Interfaz USB (sólo SC-D375(H)/D975)
Utilización de la interfaz USB
Transferring a Digital Image through a USB Connection
The Camcorder supports both USB 1.1 and 2.0 standards.
(Depends on the PC specification)
You can transfer a recorded file on a Memory Card to your PC via
a USB connection.
If you transfer data to a PC, you need to install the software (DV
Driver, Video Codec, DirectX 9.0) supplied with the Camcorder.
USB Connection Speed depending on the System
High speed USB connection is supported by Microsoft (Windows) device drivers only.
Windows 2000 - High speed USB on a system with Service Pack 4 or later installed.
Windows XP - High speed USB on a system with Service Pack 1 or later installed.
Windows VISTA- High speed USB on a system with Service Pack 1 or later installed.
System Requirements
USB interface is not supported on Windows
®
VISTA(64bit) and Macintosh operating
systems.
System requirements mentioned above are recommendations. Even on a system that
satisfies the requirements may not ensure the operation depending on the system.
[ Notes ]
On a slower PC than recommended, movie playback may not be smooth or video
editing may take a long time.
On a slower PC than recommended, movie playback may skip frames or operate
unexpectedly.
Intel
®
Pentium III™ or Pentium 4™ is a trademark of the Intel Corporation.
Windows
®
is a registered trademark of the Microsoft
®
Corporation.
All other brands and names are property of their respective owners.
Operations are not guaranteed for all of the recommended computer environments
mentioned above.
Do not connect the Camcorder to a PC using both DV and USB cables. It may not
operate properly.
In <M.Cam> or <M.Player> mode, be sure that the Memory Card is inserted into
Camcorder before connecting USB cable. If no Memory Card or an unformatted
Memory Card is inserted, PC will not recognize your Camcorder as a removable disk.
USB Streaming requires Video Codec, DV Driver and DirectX 9.0.
If you disconnect the USB cable from the PC or the Camcorder during the data
transfer, the data transfer will stop and the data may be damaged.
If you connect the USB cable to a PC using a USB HUB or with other devices at the
same time, it may cause conflict and may not work properly. If this occurs, remove all
other USB devices and try the connection again.
Transferencia de imágenes digitales mediante una conexión USB
La videocámara admite los estándares USB 1.1 y 2.0. (Depende de la
especificación del PC.)
Puede transferir un archivo grabado en una tarjeta de memoria a un PC
a través de una conexión USB.
Para transferir datos al ordenador es necesario instalar el software (DV
Driver, Video Codec , DirectX 9.0) que se proporciona junto con la
videocámara.
Velocidad de la conexión USB según el sistema
La conexión USB de alta velocidad sólo la admiten los controladores de dispositivos de Microsoft
(Windows).
Windows 2000: USB de alta velocidad en un sistema con Service Pack 4 o posterior instalado.
Windows XP: USB de alta velocidad en un sistema con Service Pack 1 o posterior instalado.
Windows VISTA: USB de alta velocidad en un sistema con Service Pack 1 o posterior instalado.
Requisitos del sistema
No se admite la interfaz USB en los sistemas operativos Windows
®
VISTA(64 bits) y Macintosh.
Los requisitos del sistema mencionados anteriormente son recomendaciones.
Incluso en un sistema que cumpla los requisitos es posible que no se asegure la operación
dependiendo del sistema.
[ Notas ]
En un PC más lento de lo recomendado, es posible que la reproducción de películas no sea
tan uniforme o puede que la edición de video tarde algo más.
En un PC más lento de lo recomendado, es posible que en la reproducción de películas se
salten fotogramas o funcione de forma inesperada.
Intel
®
, Pentium III™ o Pentium 4™ es una marca registrada de Intel Corporation.
Windows
®
es una marca registrada de Microsoft
®
Corporation.
El resto de marcas y nombres pertenecen a sus respectivos propietarios.
No se garantiza el funcionamiento en todos los entornos informáticos recomendados
mencionados anteriormente.
No conecte la videocámara a un PC utilizando los dos cables DV y USB. Puede que no
funcione correctamente.
En el modo <M.Cam> o <M.Player>, asegúrese de que la tarjeta de memoria está dentro de la
cámara antes de conectar el cable USB. Si no tiene ninguna tarjeta de memoria o tiene una sin
formato, el PC no reconocerá la videocámara como un disco extraíble.
USB Streaming requiere Video Codec, DV Driver y DirectX 9.0.
Si desconecta el cable USB del PC o de la videocámara durante la transferencia de datos, la
transferencia de datos se detendrá y puede que los datos resulten dañados.
Si conecta el cable USB a un PC utilizando el HUB USB o con otros dispositivos al mismo
tiempo, puede causar conflictos y puede que no funcione correctamente.
Si esto ocurre, retire el resto de dispositivos USB e intente la conexión de nuevo.
Procesador Intel
®
Pentium 4™, 2 GHz
OS(Sistema operativo) Windows
®
2000/XP/VISTA (32 bits)
*
Se recomienda la instalación estándar.
No se garantizan las operaciones sobre una instalación actualizada o
modificada de sistemas operativos mencionados anteriormente.
Memoria 512MB
DISCO DURO 2 GB o más
Resolución 1024 x 768 puntos / color de 24 bits
USB USB2.0 de alta velocidad
Sistema Windows
CPU Intel
®
Pentium 4™ , 2GHz
OS(Operating System) Windows
®
2000/XP/VISTA(32bit)
*
Standard installation is recommended.
Operation may not assured if the above OS has been upgraded.
Memory 512MB
HDD capacity 2GB or more
Resolution 1024 x 768 dots 24bit Color
USB USB2.0 High Speed
Windows System
01227C SCD371 USA+ESP~098 2/2/07 11:29 AM Page 93