Filter
Top Products
SPEED DOME CAMERA User Guide
10
- Avoid operating the camera for long durations under high temperatures and in high humidity. Excessive heat can
shorten the lifespan of the camera components.
- Do not install or place the camera near any heat sources.
- Subjecting the dome cover to physical shock may damage the camera.
- Do not place the camera facing direct sunlight or other intense light sources. Strong lights such as spotlights can
cause distortions—blooming and smear—as well as discolorations on the screen by heating up the color filter of
the camera. They also may cause internal reflections of the camera, leading to operational malfunctions.
- Do not drop the camera or subject it to physical shock or vibration; this can cause serious damage to the camera.
- When installing the camera near a power line, make sure to keep at least 1 meter distance from the power line,
or earth an additional metal pipe to separate the camera from the power source.
- Install this camera on the ceiling. Installing it on the ground or a unleveled location may cause product
malfunctions and shorten its lifespan.
- This product is designed to be used indoors. When installed outdoors, the camera is exposed to environmental
stress, such as water and high or low temperatures, which may degrade video quality and/or cause product
malfunctions.
- Avoid installing and operating the camera in the following places.
· Places whose temperature exceed the camera’s recommended range.
· Places where drastic temperature changes occur: e.g. Near an air conditioner.
· Places that are exposed to steam, oil, and inflammable substances: e.g. Inside a kitchen.
· Places that are exposed to radioactivity, X-rays, strong electric waves, and electro-magnetic waves.
· Places that are exposed to outdoor air contaminants: e.g. Dust and car exhaust.
· Places in high humidity.
· Places that are exposed to corrosive gas
- Smeared and dusty dome covers decrease the picture and video quality. Clean the dome cover and camera lens
on a regular basis.
- Remove the plastic wrap on the dome cover only after the camera installation is complete.
- This camera is not equipped with a power switch. Plug in the camera only after the installation is complete.
- Select an installation site (ceiling or wall) that can hold at least 5 times of the camera’s weight.
- Stuck-in or peeled-off cables can cause damage to the product or a fire.
- For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
- This product is designed for indoor use and outdoor use, separately.Take an appropriate one that suits your
needs.(Indoor: SCP-3120, Outdoor: SCP-3120V/VH)
- If you install the indoor unit outside of the building, rain, high or low temperature will affect the video quality or
may cause damage to the unit.
- Only SCP-3120V/VH
· If you turn on the camera that you have left in a place at below -50
ç
with no power supplied, the camera will
display the OSD menu after about 3 minutes.
· In a low-temp environment, the camera can't start operation right away so it takes some time to warm up and
recover its normal operation.
· If you install the camera at below 0
ç
or restart the camera after a power failure, the dome cover may be frosted.
If the dome cover is frosted, you can defrost it within 3 hours after you turned on the camera.(However, it can be
done only at higher than the minimum operation temperature of -50
ç
with no wind)
Detailed Warnings and Cautions
Warnings & Cautions