Filter
Top Products
SPEED DOME CAMERA User Guide
19
How to Set Up Protocols and ID DIP Switches
You can control various settings of the camera system using the Communication and ID DIP
switches. Before installing the product, please set up the DIP switches according to the
installation environment.
1. Detach the camera frame from the install base, and place the bottom of the frame
toward you as shown in the picture below.
2. Set the switches according to your installation environment. For more detailed setup
information, please refer to the chart on the next page.
3. The camera may malfunction if the switches are not fully turned On/Off; please double
check the switches before finishing setup.
Communication Protocol DIP Switch(SW2)
Camera ID DIP Switch(SW1)
Installing Your Camera