Filter
Top Products
SPEED DOME CAMERA User Guide
90
Troubleshooting
The camera's position
differs from the position
defined in a preset.
ĶThis phenomenon may happen, since the
motors have a margin error of ±0.1˚.
-
Sequence configuration of
the camera does not work.
ĶCheck if Preset or another operation mode
has been set.
58~62
Ķ
Check the Auto Refresh settings.
85
The upper side of the
picture is dark when the
camera is on the horizontal
reference point.
ĶYou are seeing the camera's internal
cover. The camera is functioning normally.
-
Camera suddenly turns on
or moves to a preset
position by itself.
Ķ
Check the Auto Run settings.
Auto Run puts a camera through a predefined
action sequence if the user does not use the
Controller to operate the camera for a certain
period of time.
67
• The Power cord's coating
has been damaged.
• The power cord is hot to
touch when the product is
in operation.
• The power cord gets hot
after being folded or
pulled on.
Continuing to use the product when its power
cord is damaged constitutes an electrical and
fire hazard. The power plug must be removed
from the outlet immediately, and a qualified
service personnel or your system provider
should be contacted for assistance.
-