Filter
Top Products
If you connect a remote plug to the REMOTE jack on the
rear of the camera as shown below, you can access the
menu setup mode from a remote place.
You must turn the camera power off when you connect or remove
the remote plug.
NOTE
NOTE
The phase is preset to 225 degrees at the factory. You can re-
adjust it from 0 to 270 degrees.
When the power frequency is 50Hz, you can not use linelock
mode(NTSC Models).
When the power frequency is 60Hz, you can not use the linelock
mode(PAL Models).
’Sync.’ mode is fixed to ‘INT’ in DC12V input power.
NOTE
Notes
This function resets the camera to the default settings pre-
set at the factory.
All modes are initialized and return to the default status.
Reset
Tx (Transmit Data)
GND
Rx (Receive Data)
MD (Motion Detection Signal)
Setup
Camera ID OFF
Backlight OFF
Motion Detect. OFF
Lens DC
Shutter ESC
Gain AGC
White Balance ATW
Color Auto1
Sync. INT
Reset
End
Line Lock
Phase
225
Press SET to Return
38 39
COLOR CCD CAMERA COLOR CCD CAMERA
SS
EETTUUPP
MM
EENNUU
2.5 0.5sec
+4.0V~+5.0V
0V
1. RS-232C Communication Setting.
Mode : Serial
Bit/sec : 9600bps
Port : Com1
Parity : None
2. Setup menu Command.
Setup menu Command Byte
Set A0, A0, 01, 00, 00, AF 6
Up A0, A0, 02, 00, 00, AF 6
Down A0, A0, 03, 00, 00, AF 6
Left A0, A0, 04, 00, 00, AF 6
Right A0, A0, 05, 00, 00, AF 6
3. Motion Detection Output Signal Level.
There is motion
There is no motion