Filter
Top Products
Operating Your Camera
• For NTSC models, the line-lock mode can be used if the external SYNC signal
frequency is at 60Hz.
• For PAL models, the line-lock mode can be used if the external SYNC signal
frequency is at 50Hz.
Notes
COLOR CCD CAMERA User’s Manual
41
COLOR CCD CAMERA User’s Manual
40
COMM ADJ: Use this feature to select communication
protocol (refer to p.46~ p.51 for details).
Position the indicator over
'COMMUNICATION' using the UP or
DOWN button.
IMAGE ADJ:Includes image quality or special function
factors.
•CAM ID : Assign an ID number to the camera (1 to 255).
Identification number zero is used for Remote controller setup.
•DISP CAM ID: Displays camera ID on top left corner of the screen.
•BAUD RATE : Configure baud rate from 2400/4800/9600/19200/38400/57600 bps.
•UART MODE : Configure parity bit to NON, EVEN, or ODD. Data bit is set to 8bit,
and stop bit to 1bit. Set the UART MODE to EVEN if using the Remote
Controller.
•RET PKT : Used to transfer a packet.
•END
•FREEZE: Use this feature to freeze capture an image.
•H-REV: Use this feature to horizontally inverse the screen.
•V-REV: Use this feature to vertically inverse the screen.
•SHARPNESS : Increasing this value sharpens object edges. Too high of a setting,
however, produces noise and may obscure the image.
•COLOR : Adjusting this value affects the chroma level only; the burst level is
unaffected.
To reset your camera to factory default condition.
To finish setup menu.
RESET
EXIT
END: evert back to the USER PRESET menu.