Filter
Top Products
21
4) Installing the PIR Camera (SMM-PIRCAM)
1. Choose an installation site that can sufficiently support 5 times the weight of the equipments to be
installed.
2. Remove the screw (BH M2.6) at the bottom of the main unit by turning it counterclockwise, and
then lift the assy-case front as you push it upward to detach it from the case-rear.
(
❊
Do not apply excessive force, as doing so may damage the inside assembly.
❊
)
3. Place the case-rear over the installation site and mark screw holes with a pencil (indicated by the
circles in the illustration). Drill a pilot hole for each pencil mark (5mm in diameter and at least
35mm in depth), and then fully insert the supplied plastic anchors (HUD 5) into them.
Assy-case front
Screw (BH M2.6)
CASE-REAR
SMM-15FDQ/21FDQ_ENG 9/19/03 4:50 PM Page 21