Filter
Top Products
SPEED DOME CAMERA User’s Manual
72
SPEED DOME CAMERA User’s Manual
73
Alarm Setting
Alarm Enable OFF
②Alarm Input
③Alarm Output
④Aux Output
AUX Output
On/Off OFF
Time 00 SEC
Main Menu
①Camera Setting
②Sequence Setting
③P/T Setting
④OSD Setting
⑤Alarm Setting
⑥Initialize
Status
➡
➡
25.3. Aux Output
▶
Main Menu/Alarm Setting/Aux Output
•ConnectingthepowerconnectorandGNDincorrectlytotheAuxterminal’sNOandCOM
ports may cause a short circuit and fire, damaging the camera.
•Themaximumpowercapacityofthebuilt-inrelayis30VDC/2A,125VAC/0.5A,and
250VAC/0.25A. Operating the camera beyond the capacity may decrease the camera’s
lifespan and damage it.
Notes
AUX Output menu is to operate the camera’s peripheral
devices such as lamps and sirens through the controller and
switches as well as through network communications.
On/Off
:
- Cancels or activates the Aux function.
Time
:
Enables setting up a duration for the Aux output when the
Aux command is transmitted from the controller. A
duration can be selected from a minimum of 1 second to a
maximum of 60 minutes.
⇨
NO
COM
AUX Off
NO
COM
AUX On
Functional Description Functional Description
Main Menu
①Camera Setting
②Sequence Setting
③P/T Setting
④OSD Setting
⑤Alarm Setting
⑥Initialize
Status
26. Initialization Menu
▶
Main Menu/Initialize
Power On Reset
:
Restarts the camera.
Factory Default
:
Enables resetting the camera to its factory default settings.
When the mode is selected, all custom data such as preset
locations is deleted from the camera.
Use this function if it is necessary to reset the settings of
the camera.
Camera Default
:
This mode can be used if the camera module has been
replaced and you want to keep the camera's existing
settings for the new module.
To do reset the camera, first replace the old module with a
new camera module. When the replacement is properly
installed, turn on the module, then execute this command.
Auto Refresh
:
Enables optimizing the status of the camera’s built-in
electric circuits and components on a regular basis. (A
regular operation can be scheduled.)
This mode can be used to maintain and repair the current
settings of the camera when anomalous operations occur:
e.g. The camera happened to directly face a light source, or
the settings have been canceled after the camera
repeatedly rotated in all four directions for a long time to
monitor a specific location.
The default setting is Off.
- Off, 1~7 Days: Selecting Off disables Auto Refresh and but
automatically executes it after 1~7 Days days has passed.
action once the refresh is complete.
Initialize
①Power On Reset
②Factory Default
③Camera Default
Auto Refresh OFF
⑤Auto Track Default
➡
Initialize