Filter
Top Products
SPEED DOME CAMERA User’s Manual
48
SPEED DOME CAMERA User’s Manual
49
Camera Setting
①Focus & Zoom
White Balance ATW
③Exposure
④Back Light OFF
AGC Medium
SSNR Medium
⑦Day & Night
⑧Others
Main Menu
①Camera Setting
②Sequence Setting
③P/T Setting
④OSD Setting
⑤Alarm Setting
⑥Initialize
Status
➡
8. Others
▶
Main Menu/Camera Setting/Others
Sync
: Enables selecting Internal Synchronization or the
external Line Lock. (SPD-3750T not supported)
- Internal : Synchronizes the camera’s output timing to the
internal crystal.
- Line Lock : Synchronizes the camera’s output timing to
the AC adapter power to synchronize multiple
cameras. This option is useful when using a
switch such as Matrix Switcher.
- Line Lock Phase : Enables setting the adapter’s
synchronization phase between 0 and
360°.
Stabilizer
: The Stabilizer compensates for any small
movements of the camera caused by due to
the wind and other reasonsor other causes.
Image Adj
:
- Sharpness : Sharpens outlines of an image.
- Color : Adjusts the color density of an image.
Freeze
: Stops or reanimates an image.
Dome Cover
:
These settings are to optimize the camera’s focused object
position according to the dome cover type.
- Inner : Default dome cover type including the indoor flush
model. (Factory Release Mode)
- Outer : Dome cover type for outdoor housings except the
indoor flush model.
- None : When using the camera without a dome cover.
•TheStabilizerusesthedigitalzoomandmaycause
low picture quality.
•TheStabilizerisdisablediftheambientlightistoo
low.
•TheStabilizerisdisabledifthefieldofviewhasvery
low or no contrast, e.g. The sky or a white wall.
Notes
Sequence Setting
①Preset
②Swing SEQ
③Group SEQ
④Tour SEQ
⑤PTZ Trace
⑥Auto Run
Power On Resume ON
MD Dwell Time ON
Main Menu
①Camera Setting
②Sequence Setting
③P/T Setting
④OSD Setting
⑤Alarm Setting
⑥Initialize
Status
➡
9. Power On Resume and MD Dwell Time
▶
Main Menu/Sequence Setting
Power On Resume
:
This is useful when the power is disconnected and
reconnected due to power failures or other power
interruptions.
If the camera was performing a sequence action prior to a
power disconnection, the camera automatically resumes
the action when the power is reconnected.
MD Dwell Time
:
When Motion Detection under the Preset Edit menu is
selected, MD Dwell Time performs the Tour or Group
function.
While the camera is performing a sequence action, if
motion is detected from a selected preset location, the
camera pauses the sequence action operation and starts
monitoring the location instead for a duration that is set
under the MD Dwell Time menu.
If the motion is no longer detectable or the duration
expires, the camera aborts the monitoring operation and
then resumes the sequence action.
Sequence Setting
Functional Description Functional Description
Others
Sync INTERNAL
Stabilizer OFF
③Image Adj
Freeze OFF
Dome Cover Inner
➡