Filter
Top Products
English _65
USING THE DVR
• Focus : Enables you to adjust the focus manually.
• Auto Pan : The camera automatically runs between the two points that you selected.
• Scan : The camera moves to the preset points in the specified sequence.
If multiple presets are specified, the PTZ camera will automatically move to all of the preset points one at a
time.
• Pattern : Makes the PTZ camera remember and follow the past route.
The functions of Auto Pan, Scan and Pattern are supported in the protocols of Samsung, Panasonic and Pelco, and are
different in terms of the name and setting, depending on the protocols of Samsung, Panasonic and Pelco.
(Panasonic : Auto Pan, Sequence, Sort / Pelco : Auto Pan, Frame Scan (Scan), Pattern)
M
Before entering the PTZ device control mode, set the values of the PTZ device in the <Setting the PTZ> menu.
(Page 43)
Preset Setting
A preset is a set of specific target points of a PTZ camera, and up to 20 presets per a camera can be stored.
Using the mouse may help make setup easier.
1. In PTZ Control mode, use the direction buttons to adjust the camera in a desired direction.
2. Select the <Save> key.
The virtual keyboard for inputting the preset will appear.
Refer to “Using Virtual Keyboard”. (Page 34)
• Save : You can save the preset settings.
• Rename : You can change the settings of the existing presets.
• Delete : Deletes the selected preset.
• Delete All : Deletes all existing presets.
M
If you replace the camera of the channel that stores the preset list with a new one, you should reset the preset
accordingly.
3. Press <OK>.
The preset will be saved as a name that you entered.
Camera Setting
A PTZ camera has its own menu system. Optimize the PTZ camera according to the DVR.
Using the mouse may help make setup easier.
1. Connect the PTZ camera to the DVR and run the PTZ
camera again to display the camera’s protocol setting
window.
2. Check the protocol ID of the camera.
In “Device > Setting the PTZ”, enter the PTZ camera ID in the
ID input box of the channel that is connected to the PTZ camera.
(Page 43)
3. Select <Camera Setup> in the PTZ Control menu.
The camera-specific menu appears.
You can configure the settings of only those cameras that support
the protocols of Samsung, Pelco D/P, AD and Panasonic.
If you are setting Auto Pan or Pattern in the camera menu, press
and hold the appropriate button for a certain time so that the button
operation can be different from that in normal PTZ setting.
2011-01-01 01:10:25
SAMSUNG PROTOCOL
SAMSUNG PROTOCOL
ADDR 0
ADDR 0
TYPE RS-485,HALF
TYPE RS-485,HALF
BAUD 9600
BAUD 9600
LENS OK!
LENS OK!
TILT OK!
TILT OK!
PAN OK!
PAN OK!
2011-01-01 01:10:25
**
**
MAIN MENU
MAIN MENU
**
**
CAMERA SET
...
...
VIDEO SET...
VIDEO SET...
PRESET...
PRESET...
ZONE SET...
ZONE SET...
AUTO SET...
AUTO SET...
ALARM SET...
ALARM SET...
OTHER SET...
OTHER SET...
CLOCK SET...
CLOCK SET...
SYSTEM INFO...
SYSTEM INFO...
Camera Setup
Exit