Samsung SVD-4700 Security Camera User Manual


  Open as PDF
of 25
 
COLOR DOME CAMERA User Guide
18
COLOR DOME CAMERA User Guide
19
MAIN SETUP
SSDR OFF
WHITE BAL ATW
BACKLIGHT OFF
Operating Your Camera
SSDR (Samsung Super Dynamic Range)
SSDR illuminates darker spots of an image while retaining the same light level for brighter
spots to even out the overall brightness of images with high contrast between bright and
dark spots.
SSDROFF
1. When the SETUP menu screen is displayed, select ‘SSDR’ by using the switch so that the
arrow indicates ‘SSDR’.
2.
Use the switch to change the SSDR level according to the contrast between bright and dark areas.
SSDRON
MAIN SETUP
SSDR OFF
WHITE BAL ATW
Select one of the following 5 modes, as appropriate for your purpose.
ATW : Select this when the color temperature is between 1,800˚K and 10,500˚K.
MANUAL :Selectthistofine-tuneWhiteBalancemanually.SetWhiteBalancefirstby
using the ATW or AWC mode. After that switch to MANUAL mode, fine-
tunetheWhiteBalanceandthenpresstheFunctionSetupswitch.
AWCSET : To find the optimal luminance level for the current environment, point the
camera towards a sheet of white paper and press the Function Setup
switch. If the environment changes, readjust it.
OUTDOOR : Select this when the color temperature is between 1,700˚K and 11,000˚K.
(sodium light inclusion)
INDOOR : Select this when the color temperature is between 4,500˚K and 8,500˚K.
•WhiteBalancemaynotworkproperlyunderthefollowingconditions.Inthiscase
selecttheAWCmode.
Whenthecolortemperatureoftheenvironmentsurroundingthesubjectisoutofthe
controlrange(e.g.clearskyorsunset).
Whentheambientilluminationofthesubjectisdim.
Ifthecameraisdirectedtowardsafluorescentlightorisinstalledinaplacewhere
illuminationchangesdramatically,theWhiteBalanceoperationmaybecomeunstable.
Notes
UsetheWhiteBalancefunctiontoadjustthescreencolor.
1.WhentheSETUPmenuscreenisdisplayed,select‘WhiteBal’byusingtheFunctionSetup
switchsothatthearrowindicates‘WhiteBal’.
2. Select a desired mode using the Function Setup switch.
White Balance (White Bal)
 previous next