Filter
Top Products
Adjusting the LCD during PLAY
✤ You can adjust the LCD during playback.
✤ The adjustment method is the same procedure as used in
CAMERA mode. (see page 31)
The Speaker works in PLAYER mode only.
■
When you use the LCD screen for playback, you can hear
the recorded sound from he built-in Speaker.
- Follow the instructions below to decrease or mute
speaker volume in the PLAYER mode.
- Take the following steps to lower the volume or mute
the sound while playing a tape on the camcorder.
1. Set the power switch to PLAYER mode.
2. Press (PLAY/STILL) to play the tape.
3. When you hear sounds once the tape is in play, use the
MENU DIAL to adjust the volume.
■
A volume level display will appear on the LCD.
Levels may be adjusted from anywhere between 00 to
19 and you will not hear any sound when the volume
is set on 00.
■
If you close the LCD while playing, you will not hear
sound from the speaker.
Reference
■
When the cable is connected to the A/V jack, you cannot
hear sound from the camcorder speaker and
cannot adjust the volume.
■
But, even if cable is connected to the A/V jack, you can
hear sound from the camcorder speaker when AV IN/OUT
MODE on MENU is set to AV IN MODE. (VP-D23i/D24i only)
■
You can hear sound from camcorder speaker by removing the connected
cable from the A/V jack
Basic Recording
3434
ENGLISH
0 : 2 3 : 4 7
5 5 min
1 0 : 0 0
1 0 . J A N . 2 0 0 3
VOL. [ 1 1 ]
<3-2>
Controlling Sound from the Speaker
VOL / MF
PLAY
✤
✤ CAMERA 31
PLAYER
■
Speaker
- PLAYER
-
1. PLAYER
2. PLAY/STILL /
3. MENU DIAL
■
00 19 00
■
■
A/V
■
MENU AV IN/OUT MODE
/ AV I N
A/V
VP-D23i/D24i
■
A/V