Filter
Top Products
119
ENGLISH
Troubleshooting
If these instructions do not solve your problem, contact your
nearest Samsung authorized service certre.
Symptom Explanation/Solution
You cannot switch the
DVD Camcorder on.
Check the Battery Pack or the AC Power
adapter.
The DVD Camcorder
shuts off automatically.
You have left the DVD Camcorder set to
STBY for more than 5 minutes without
using it. To turn on the DVD Camcorder,
press the [Start/Stop] button.
The Battery Pack is fully exhausted. Replace
it with a fully charged charged battery pack.
Charge runs out
quickly.
The atmospheric temperature is too low.
The Battery Pack has not been charged fully.
The Battery Pack is completely dead,
and cannot be recharged, use another
Battery Pack.
A vertical strip appears
on the screen when
recording a dark
background.
The contrast between the subject and
the background is too great for the DVD
Camcorder to operate normally. Make
the background bright to reduce the
contrast or use the BLC function while
you are recording in bright Surroundings.
The image in the
Viewfinder is blurred.
The Viewfinder lens has not been
adjusted.
Adjust the Viewfinder control lever
until the indicators displayed on the
Viewfinder come into sharp focus.
Auto focus does not
work.
Check the Manual Focus menu.
Auto focus does not work in the Manual
Focus mode.
When the power is
turned off and then
turned on, a blue
screen appears instead
of the normal screen.
If the DC Adapter is connected, remove
the cord, turn on the Power switch, and
then connect it again. If the battery is
connected, disconnect it, turn the Power
switch to on, and then connect it again.
中 文
故障排除
如果故障没有解决，请与三星授权的当地客服中心联系。
现象 原因/排除方法
您无法打开DVD摄像机的
电源。
检查电池组或交流适配器。
DVD摄像机自动关闭。
您将DVD摄像机设置为超过5分钟不使用
它。若要打开DVD摄像机的电源，请按
下[Start/Stop]按钮。
电池组已完全耗尽电量。请换上完全充
电的电池组。
电量很快耗尽。
环境温度太低。
电池组未完全充满电。
电池组已损坏而且不能再充电，请更换
新的电池。
在拍摄时暗部背景出现垂
直条纹。
物件与背景之间的对比太大，使DVD摄
像机无法正常操作。被摄体与背景的对
比过大，使本机无法正常操作，提高背
景亮度，减少反差或者使用BLC（背光
补偿）功能。
取景器中的影象不清楚。
取景器的镜头尚未调节。
调节取景器的控制杆，直至取景器上显
示的指示符位于强聚焦的范围内。
自动聚焦功能失灵。
检查手动聚焦菜单。
手动聚焦模式下，自动聚焦不起作用。
关闭电源然后重新打开
时，将出现蓝屏，而不是
正常的屏幕。
若连接的是交流电源适配器，请拔下电
线，打开电源开关，然后再次连接。若
连接的是电池，请断开连接，将电源开
关转到开位置，然后再次连接。