Filter
Top Products
CONNECTIONS AND INSTALLATION
2 Install the camera unit onto the base.
Connect the video signal cable plug (B) and the power supply cable plug (C) from the base
to their respective connectors on the camera unit. Then install the camera unit onto the
base.
3 Securely tighten the four camera unit fixing screws (D) evenly.
Camera removal
1 Loosen the four camera unit fixing screws (A) evenly.
2 Turn the camera unit of about 80˚, in the direction of the arrow shown on the
illustration.
Turn the camera unit all the way until screw (B) on the base reaches the tab.
3 Remove the camera unit.
To remove the camera unit, carefully apply a slight force until the screw (B) goes over the
tab, then carefully remove the camera unit.
CAUTION:
• When removing the camera unit, be careful not to hurt yourself with the camera unit
fixing screws.
• When removing the camera unit, be careful as the video signal plug (B) or power supply
plug (C) cables are short and may become unplugged.
A
A
A
A
B
B
B
C
L73D4/US GB 1998, 3, 12
English 10