Filter
Top Products
SETTINGS AND ADJUSTMENTS
Line phase adjustment
When using a camera switcher to connect two cameras or more to one monitor, there may be
a vertical roll of the images when switched, if the phases differ. In such a case, adjust as
described below.
Using the camera switcher, switch the display on the monitor from camera 1 to camera
2.
Adjust the L-PHASE volume control on camera 2 until the vertical roll of the image stops.
If more than two cameras are used, please repeat this procedure for all the cameras.
NOTE:
If the vertical roll cannot be corrected by adjusting the L-PHASE volume on camera 2, try
adjusting the L-PHASE volume on camera 1. If it still cannot be corrected, please check that
the polarity of the power cords of all connected devices is correct.
L-PHASE
1234
IN IN
OUT