Filter
Top Products
9
Installation
Remove the wire gutter cover (AA).
If you use a USB cable or an HDMI cable,
secure it along with the LAN cable using the
supplied fixer (C) so that the cables don’t
easily come off.
When you route the cables after installing
the camera, be sure to carefully handle the
cables so as not to strongly pull them.
(AA)
(C)
When routing cables through the side face of the camera
Using the supplied pattern sheet, drill the holes for the cables and screws.
Pull out the cables from the ceiling.•
Attach the supplied mounting plate to the ceiling using commercially-available screws.
(Screw: M4/No. 8 or equivalent) Length: 40 mm/1.6 in or more, Head: φ 8.3 mm/0.3 in
Loosen the screw (A) and remove the cable holder (B).
(B)
(A)
•
Hook the safety cable attached on the camera base to the mounting plate.
Connect the cables from the ceiling to the camera cables. ( Page 5 “Basic Connections”)
After connecting each of the terminals (LAN, USB, HDMI), put the cable holder (B) back to its
original position so as to hold all the cables in place, and tighten the screw (A).
Using the supplied fixer (C), tidy the wiring by binding all the cables to make the installation
easier.
(B)
(C)
(A)
After binding, cut off the
excess portion of the fixer.