Filter
Top Products
4
Name and Function of Each Component
Side Cover
Fall-prevention screw
SD Card slot
Power indicator
This indicator lights up when the camera is powered on.
When the camera is on, this indicator blinks to indicate the following camera statuses:
Deactivation of recording to SD memory card in progress
Firmware update in progress
An SD memory card error occurred (Fast blink)
•
•
•
SD CARD button
Disable recording: The power indicator blinks when this button is pressed, and stays lit when
the SD memory card is prepared to be removed.
Enable recording: The power indicator blinks when this button is pressed, and stays lit when
the SD memory card is recognized.
Before you insert an SD card, be sure to turn off the camera.
If you insert an SD card, format it via network operation on the SD/HDD screen.
(
Electronic manual)
•
•
SD memory card
How to insert the SD card
To record live video on a SD memory card, open the cover
as shown below and insert the card into the card slot until
you hear a click.
•
SD CARD button
Power indicator
How to remove the SD card
Press the SD CARD button and, after confirming that the
indicator lamp has stopped blinking and now stays lit, take
out the SD card.
•
External HDD
Use the optional hard disk case (VA-HDC4000) to install the SANYO-specified 2.5" SATA hard
disk drive and connect the drive to the EX-HDD terminal.
For detailed information on the hard disk case including hard disk installation, refer to the
instruction manual supplied with the hard disk case.
■
■
•
•
Installing Recording Media