Filter
Top Products
LENS SETTING (LENS)
4
DNR setting
Use the cursor button (
j
or
l
) to move the cursor to
DNR, and then use the cursor button (
d
or
c
) to select
the digital noise reduction setting (e.g. ON).
Available settings:
•
ON:
DNR (digital noise reduction) is applied. This reduces
interference at low luminance levels.
•
OFF:
DNR is not applied.
Note:
• Digital noise reduction operates when the gain control
increases. In addition, blurring and ghosting of images can
occur when moving images are being monitored, and so the
resolution is also reduced slightly.
• If AGC MAX GAIN is set to “
OFF
”, DNR will be forcibly set to
“
OFF
”.
5
BURST setting
Use the cursor button (
j
or
l
) to move the cursor to
BURST, and then use the cursor button (
d
or
c
) to
select the burst setting (e.g. ON).
Available settings:
•
ON:
The color burst signal is turned on.
•
OFF:
This should normally be set to “
OFF
”.
6
FOCUS setting
Use the cursor button (
j
or
l
) to move the cursor to
FOCUS, and then use the cursor button (
d
or
c
) to
select the focus setting (e.g. 1).
Available settings:
•
1:
Near-infrared wavelength correction is set.
(around 900 nm)
•
2:
Visible light spectrum is set.
Note:
This is set to “
1
” at the time of shipment from the factory.
If the images are out of focus, change it to “
2
”.
☞
To close the menu screen or return to the previous
screen, select BACK or END for MENU and press the SET
button.
4 5, 6
D/N SETTING - B/W
AGC MAX GAIN +6·
DNR ON
BURST OFF
FOCUS 1
PRESET OFF
MENU BACK
D/N SETTING - B/W
AGC MAX GAIN +6·
DNR ON
BURST ON
FOCUS 1
PRESET OFF
MENU BACK
L5AD2/US (VCC-ZM400) GB 2003, 2, 4
English
30