Filter
Top Products
11
Preparation
Installing the Battery to
Remote Control (Not sup-
plied)
The remote control (RRMCGA149WJSA)
is not supplied with this camcorder.
Contact the nearest SHARP service
center or your dealer for purchasing as
specified part.
The CR 2025 type lithium battery is used
to power the remote control unit.
1 Hold the remote control facing down,
and pull out the battery holder while
pressing the tab toward the center.
2 Insert the CR 2025 type lithium
battery into the battery holder with
the H side of the battery facing the
m side of the holder.
3 Insert the battery holder back into
position.
Notes on the Use of the Lithium
battery
• Do not short-circuit, recharge, disassemble,
or heat the lithium battery.
• Should the lithium battery leak, wipe the
battery compartment clean, and then insert a
new battery.
• The lithium batteries will last about one year
under normal usage.
CAUTION The battery used in this
device may present a risk of fire of
chemical burn if mistreated. Do not
recharge, disassemble, heat above
212°F (100°C) , or incinerate. Replace
battery with the type CR1216 for the
camcorder and the type CR2025 for the
remote control unit of Toshiba Battery
Co., Ltd. only. Use of another battery
may present a risk of fire or explosion.
Dispose of used battery promptly. Keep
away from children. Do not disassemble
and do not dispose of in fire.
“m” side
H side, CR 2025 type
lithium battery
Ta b